Εμφάνιση αποτελεσμάτων : 1 έως 5 από 5

Θέμα: [Ε46] Ζώνη ασφαλείας πρόβλημα επαναφοράς

Hybrid View

Προηγούμενο μήνυμα Προηγούμενο μήνυμα   Επόμενο Μήνυμα Επόμενο Μήνυμα
  1. #1
    Εγγραφή
    23-12-09
    Περιοχή
    Αθήνα
    Μηνύματα
    11.265
    Thanked
    14148
    Rides
    1

    Προεπιλογή

    Έτσι βγαίνει το pillar. Απο πίσω θα βρεις το μηχανισμό της ζώνης

    1. Remove front and rear door sills.




    2. Lift up (hard) and out on the lower b-pillar trim panel



    Notice the rivets that you pulled the lower b-pillar over. (I found it difficult to get the lower b-pillar back over these when I was putting it back together so I replaced them and put them in the lower b-pillar first and it snapped in no problem.)




    3. Remove the expanding rivets at the bottom of the upper b-pillar.





    4. Pull down on upper b-pillar and it's free.



    SEAT BELT

    A. Start at the rear of the seat to take the control module cover off




    B. Take the cover off. There are clips that are connected underneath the cover; make sure not to break them.




    C. There is a lug nut that keeps your seat belt in place, remove it.




    D. Fin




    Hope this helps anyone who needed a visual aid on how to remove their b-pillars. __________________
    https://forum.e46fanatics.com/showthread.php?t=961827



  2. The Following 4 Users Say Thank You to BILL007 For This Useful Post:

    A8hnaios (10-11-15), Dathanaso (10-11-15), nikos valvetronic (10-11-15), Nino (11-11-15)

Δικαιώματα - Επιλογές

  • Δεν μπορείτε να δημοσιεύετε νέα θέματα
  • Δεν μπορείτε να απαντάτε σε θέματα
  • Δεν μπορείτε να δημοσιεύετε συνημμένα
  • Δεν μπορείτε να επεξεργάζεστε τις δημοσιεύσεις σας
  •  
BACK TO TOP